How To Quickly Grasp The Surface Temperature of The Rubber V-belt And How To Avoid Burning

Recently, many users have reported that they encountered burning when using the V-belt, which caused the equipment to fail to operate normally. In order to solve this problem, we share with you some methods to quickly grasp the surface temperature and avoid burning. First, it is key to understand the normal temperature of the rubber belt. During the operation of the V-belt, its surface temperature should generally not exceed 60-70 degrees Celsius. If the temperature is too high, it may mean that the belt is slipping or the transmission load is too large, resulting in excessive wear and burning of the belt.

To quickly grasp the surface temperature of the V-belt, you can take the following measures:

1. Check the load of the transmission device: Make sure that the load of the transmission device is within the bearing range of the V-belt. Excessive load may cause excessive wear and burning of the belt.

2. Check the belt regularly: Regularly check the tension and wear of the V-belt, and replace the belt with severe wear in time.

3. Monitor the operation of the equipment: Install relevant monitoring equipment to monitor the operating status of the V-belt in real time, detect abnormalities early and deal with them in time.

Once the surface temperature of the V-belt is found to be too high, we should take the following measures to avoid burning:

1. Check whether the pulley is intact: the wear of the pulley may increase the transmission load, causing the belt to burn. Regular inspection and replacement of the pulley can avoid this problem.

2. Adjust the tension: Make sure the tension of the V-belt is moderate. Too loose or too tight may cause the belt to slip or excessive wear.

3. Avoid long-term overload operation: Reasonably distribute the equipment load to avoid overloading the V-belt for a long time.

4. Add lubricant: Add lubricant between the V-belt and the pulley to reduce friction and wear and reduce the risk of burning.

5. Regular maintenance and care: Regularly maintain and care for the equipment to ensure the normal operation of each component.

In short, mastering the surface temperature of the rubber belt and taking corresponding measures can effectively avoid burning. By regularly checking, adjusting and maintaining the equipment, you can ensure the safe operation of the V-belt and extend its service life. The above content is for reference only, and you can adjust and optimize according to actual conditions.