Views: 1 Author: Site Editor Publish Time: 2024-01-15 Origin: Site
The ordinary rubber material rubber belt is generally composed of a wrapping layer, an extension layer (top glue), a strong layer (tensile layer), and a compression layer (bottom glue). Before installing the V-belt, if the center distance between the two axes is an adjustable structure, the center distance should be shortened first, and then the center distance should be adjusted according to the requirements after the tape is installed; If the center distance between the two axes is not adjustable, you can first insert a V-belt into the wheel groove, then rotate the other pulley to install the V-belt, and use the same method to install a set of V-belts. During installation, it is prohibited to use tools to forcefully pry or pull on the rubber tape to prevent it from extending or becoming too loose or tight.
The correct inspection method is to apply about 2 kilograms of vertical pressure by hand in the middle of each tape, with a sinking amount of (20-30) millimeters. If it is not suitable, it should be adjusted in a timely manner. When replacing double or three or more rubber v belt tapes, it is necessary to choose the specified model of rubber v belt tape and ensure that the tightness of each group of rubber belt tapes is consistent. It is not allowed to mix new and old tapes or reduce the number of tapes used. Otherwise, the force on the new and old v belt tapes will be uneven, and even the old ones will not work, affecting power transmission and shortening the service life of the v belt tapes.