Analysis of The Reasons for The Flipping Or Falling Off of The Rubber Belt And Solutions

Reason 1: The V-belt pulley is not aligned properly

Solution: Align the pulley

Reason 2: Poor design of the transmission device

Solution: Check the stability of center distance and the attenuation of vibration

Reason 3: There are external objects falling inside the groove of the V-belt pulley

Solution: Protect pulley grooves and transmission devices

Question 4: Impact load or vibration

Solution: Check the design of the transmission device using a power band or power cable belt

Reason 5: Belt specifications do not match

Solution: Replace with a new and correct belt (new and old belts should not be mixed)

Reason 6: Wear and tear on the groove of the V-belt pulley

Solution: Replace the pulley

Reason 7: Damage to tension components

Solution: Use the correct installation method and belt storage program

Reason 8: Incorrect placement of flat idle pulley

Solution: Carefully adjust the flat idle pulley on the loose side of the transmission and make it as close as possible to the R pulley of the transmission device