The Causes And Solutions of Cracks in Rubber Belts
Publish Time: 2024-03-12 Origin: Site
The causes and solutions of cracks in rubber belts
Cause of cracks:
1. The diameter and installation position of the tensioning wheel do not meet the requirements;
2. Severe slipping;
3. The diameter of the pulley is lower than the smaller allowable diameter limit for automotive transmission belts;
4. Chemical factors have an impact.
Solution:
1. Pay attention to the installation method and meet the installation requirements;
2. Adjust the tension as required;
3. Redesign or use toothed rubber belts;
4. Improve conditions or use special V-belts.