Pay attention to these problems of v belt when the combine harvester harvests corn！

Corn, as an important crop, has always been planted by farmers. In the past, due to the backwardness of science and technology, corn harvesting could only be completed manually, which was time-consuming, laborious and efficient. In recent years, with the progress of the, corn combine harvester has gradually come into people's vision.

However, when science and technology brings convenience, it is also accompanied by some potential safety hazards. We'd better pay attention to these matters when using the corn combine every day, otherwise it may cause some unnecessary safety accidents during harvesting.

The first thing that should be considered during the use of the corn harvester is to find out the specific conditions of the harvested land in advance

If the land to be harvested is small and the distance is short, the best way is to harvest it manually and mechanically. That is, first manually remove some fallen or fallen corn. This can reduce the loss during corn harvesting and greatly increase the use efficiency of the harvester.

Precautions for use of corn combine harvester and trial harvest

When using the corn combine harvester, it is usually necessary to carry out trial harvest, that is, only harvest a little to see the operation of the whole harvester. If the harvester is in good condition, it can be harvested formally. During the trial harvest, it should be noted that the first gear must be used for harvest. If the first gear works normally, the high gear can be used for harvesting

Considerations during harvesting

The operator should master the operating lever skillfully to ensure that the height of the harvester head is consistent with the height of the plot during harvesting. It cannot be too high, otherwise the straw will be too long or too low, otherwise it will bring soil in the corn. Moreover, during the whole operation process of the harvester, you can't remove the fault by hand, and you can't touch the running parts by hand. If troubleshooting is required, be sure to stop and shut down before troubleshooting. Corn harvester is a very complex large machinery, and the whole transmission chain is very long and complex. If one transmission part is damaged, the whole harvesting unit will stop running. Therefore, in the process of using the harvester, we must strictly abide by the operation specifications to avoid unnecessary safety accidents.

As farmers, we should try not to get close to the harvester in the whole harvest process. We should not take risks to get close to the harvester in order to love food. This will not only not recover the losses, but also cause serious personal safety accidents.

Now it is the corn harvest season. I hope we can not only enjoy the convenience brought by science and technology, but also protect our own safety. Finally, I wish everyone a good harvest this year.

Hebei Heiyi Rubber Co., Ltd., specializing in the production of toothed belt for more than 20 years.

Company purpose: focus on the production and R & D of high-end agricultural machinery toothed belt, and strive to achieve win-win results for customers, teams and enterprises

Company mission: to provide customers with a steady stream of power with ingenious quality and cutting-edge technology, and make unremitting efforts for the development of global agricultural machinery industry and scientific and technological progress!