In the field of industrial transmission, the choice of material for the V-belt, as an important transmission component, directly affects the transmission performance and service life. At present, the commonly used rubber belt materials in the market mainly include rubber, polyurethane, and polyester

Preparation: Firstly, ensure that you have prepared the new rubber v belt and check if its model and specifications match the old belt. At the same time, make sure you have suitable cutting tools and fasteners, and prepare lubricants for easy installation.

There are several key points to distinguish the quality of a rubber belt:Material: Good V-belts are usually made of high-quality materials, such as high-quality leather or elastic fabrics. When touched, it should feel soft but sturdy, with no obvious signs of wear or breakage.Craftsmanship: Observe

Analysis of the reasons for the flipping or detachment of the V-belt:1. Quality issue with the V-belt: The purchased V-belt has poor quality, insufficient tensile strength, and is prone to flipping or falling off after prolonged use.2. Improper installation: During the installation process, the tria

As a type of transmission belt, V-belts are widely used in various mechanical equipment. However, the rubber belt often experiences grooving, which not only affects the normal operation of the equipment, but may also cause damage to the equipment and safety accidents. So, what is the reason why the rubber belt always goes out of the groove?

During use, if there is a fracture in the rubber belt, it may be caused by various factors. One possibility is that the internal structure of the rubber belt may change due to prolonged use, resulting in fracture behavior. If any negative signs are found, replace it with a new one as soon as possible. So what causes a good triangular belt to suddenly break?