The causes and solutions of cracks in rubber beltsCause of cracks:1. The diameter and installation position of the tensioning wheel do not meet the requirements;2. Severe slipping;3. The diameter of the pulley is lower than the smaller allowable diameter limit for automotive transmission belts;

In modern industry, there are mainly mechanical transmission, hydraulic transmission, pneumatic transmission, and electrical transmission. Among them, mechanical transmission is the basic transmission mode, which transmits motion force and motion through meshing transmission and friction transmission, and plays an important role in it. The degree of tightness is usually determined based on usage experience, and it is good to adjust it so that the belt does not slip during transmission.

When the rubber belt makes noise, you can try the following methods to solve the problem: check the tightness of the triangle belt: ensure that the tightness of the triangle belt is appropriate. If it is too tight or too loose, it may cause noise. You can achieve the appropriate tightness by adjusting the rubber v belt tensioner or the elastic screw.

Banded V belts are commonly used transmission components, and they need to be matched with corresponding pulleys to achieve transmission. Compared with ordinary flat belts, the combined rubber belt is embedded in the ring groove of the pulley, making it difficult to separate from the pulley and able to withstand corresponding lateral forces.

Joint triangular toothed belts generally refer to cloth wrapped V-belts. Since the 1960s, in order to improve the performance of transmission belts, cut edge V-belts have emerged. This type of cut edge V-belt has developed due to the lack of cloth wrapped on the side of the tape structure, which makes the belt soft and has good resistance to bending fatigue.

Remove the edges of the vulcanized v belt product along with the waste edges under freezing conditions. Over the past few decades, with the selection and replacement of refrigeration media, as well as the improvement of mechanical actions, refrigeration trimming has also undergone several generations of improvement, becoming increasingly mature and excellent, with significant improvements in work speed and processing quality.